Witam,
Proszę o pomoc w instalacji oprogramowania wraz ze sterownikami do urządzenia PCA 86010046. Aplikacje zainstalowałem po przez wine ale niestety apka nie widzi urządzenia. Urządzenie pracuje po przez konwertowanie sygnału usb do com.
norbert@norbicom:~$ lspci
00:00.0 Host bridge: Intel Corporation Sky Lake Host Bridge/DRAM Registers (rev 08)
00:02.0 VGA compatible controller: Intel Corporation Sky Lake Integrated Graphics (rev 07)
00:14.0 USB controller: Intel Corporation Sunrise Point-LP USB 3.0 xHCI Controller (rev 21)
00:14.2 Signal processing controller: Intel Corporation Sunrise Point-LP Thermal subsystem (rev 21)
00:16.0 Communication controller: Intel Corporation Sunrise Point-LP CSME HECI (rev 21)
00:17.0 SATA controller: Intel Corporation Sunrise Point-LP SATA Controller [AHCI mode] (rev 21)
00:1c.0 PCI bridge: Intel Corporation Device 9d12 (rev f1)
00:1c.5 PCI bridge: Intel Corporation Sunrise Point-LP PCI Express Root Port (rev f1)
00:1f.0 ISA bridge: Intel Corporation Sunrise Point-LP LPC Controller (rev 21)
00:1f.2 Memory controller: Intel Corporation Sunrise Point-LP PMC (rev 21)
00:1f.3 Audio device: Intel Corporation Sunrise Point-LP HD Audio (rev 21)
00:1f.4 SMBus: Intel Corporation Sunrise Point-LP SMBus (rev 21)
00:1f.6 Ethernet controller: Intel Corporation Ethernet Connection I219-V (rev 21)
01:00.0 Network controller: Intel Corporation Intel Dual Band Wireless-AC 3165 Plus Bluetooth (rev 99)
02:00.0 Unassigned class [ff00]: Realtek Semiconductor Co., Ltd. RTS522A PCI Express Card Reader (rev 01)
norbert@norbicom:~$ ls -al /dev/serial/by-id/usb*
lrwxrwxrwx 1 root root 13 paź 17 14:01 /dev/serial/by-id/usb-KATHREIN_KATHREIN_PCA_86010046-if00-port0 -> ../../ttyUSB0
norbert@norbicom:~$ lsusb
Bus 001 Device 009: ID 0403:6001 Future Technology Devices International, Ltd FT232 USB-Serial (UART) IC
Więc tak: skoro to w sumie jest port szeregowy i jeżeli w programie do zarządzania możesz wybrać dowolny port, w tym zwykły szeregowy (nie USB) to możesz podlinkować urządzenie /dev/ttyUSB0 do ~/.wine/dosdevices/com1:
ln -s /dev/ttyUSB0 ~/.wine/dosdevices/com1
i upewnić się, że masz uprawnienia do dostępu do tego portu (np. w Ubuntowatych musisz należeć do grupy dialout)
Jak program je jest zbyt wymyślny, to nie powinien zauważyć podmianki.