>jesli uzywasz jadra z serii 2.6 parametry modulow okresla sie w /ertc/modprobe.conf
to jest jądro 2.4
> A co w ogole mowi:
> modinfo e1000
>
> Nie kazdy kompiluje ten sterownik ;-)
wydruk modinfo -p
debug int, description "Debug level (0=none,...,16=all)"
TxDescriptors int array (min = 1, max = 32), description "Number of transmit descriptors"
RxDescriptors int array (min = 1, max = 32), description "Number of receive descriptors"
Speed int array (min = 1, max = 32), description "Speed setting"
Duplex int array (min = 1, max = 32), description "Duplex setting"
AutoNeg int array (min = 1, max = 32), description "Advertised auto-negotiation setting"
FlowControl int array (min = 1, max = 32), description "Flow Control setting"
XsumRX int array (min = 1, max = 32), description "Disable or enable Receive Checksum offload"
TxIntDelay int array (min = 1, max = 32), description "Transmit Interrupt Delay"
TxAbsIntDelay int array (min = 1, max = 32), description "Transmit Absolute Interrupt Delay"
RxIntDelay int array (min = 1, max = 32), description "Receive Interrupt Delay"
RxAbsIntDelay int array (min = 1, max = 32), description "Receive Absolute Interrupt Delay"
InterruptThrottleRate int array (min = 1, max = 32), description "Interrupt Throttling Rate"
przy okazji ethtoolem (v.1.8)też niczego nie mogę zmienić, ethtool wyswietla aktualne opcje sterownika, ale gdy chce cos zmienic to nie robi nic...