Witam.
mam taki oto kontroler podpięty pod PCI:
03:06.0 RAID bus controller: Silicon Image, Inc. PCI0680 Ultra ATA-133 Host Controller (rev 02)
Subsystem: Silicon Image, Inc. Winic W-680 (Silicon Image 680 based)
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
SERR- Latency: 32, Cache Line Size: 4 bytes
Interrupt: pin A routed to IRQ 20
Region 0: I/O ports at cf00 [size=8]
Region 1: I/O ports at ce00
Region 2: I/O ports at cd00 [size=8]
Region 3: I/O ports at cc00
Region 4: I/O ports at cb00 [size=16]
Region 5: Memory at fdcff000 (32-bit, non-prefetchable) [size=256]
[virtual] Expansion ROM at fdb00000 [disabled] [size=512K]
Capabilities: [60] Power Management version 2
Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=2 PME-
Kernel driver in use: pata_sil680
Kernel modules: pata_sil680
Bios kontrolera widzi podpięty dysk, więc sprawa od strony technicznej jest OK.
Ale jak dostać się do tego dysku? fdisk -l widzi tylko urządzenia pod IDE z płyty głównej.
Czy jest ktoś z Was, zaawansowanych kolegów i koleżanek, w stanie mi pomóc?
Pozdrawiam
ShiroiKuma.
update:
- dysk padł, dlatego system go nie wykrywał... :/